#Xtc clip box how to
#Xtc clip box software

#Xtc clip box software

Please note,that unlike mentioned files,SIM lock configuration 'config.dat' is a binary file,and you may need to use a hex editor to create it.Therefore it's recommended that you use an XTC 2 Clip software to create/manage this file. It may happen that you need to create service files on a PC with no XTC 2 Clip software installed.In this case you can manually create the files for: OTHERWISE YOU WILL GET 'IMEI CHECKING FAIL' AND YOUR PHONE WILL NOT BE UNLOCKED/LOCKED! CID,IMEI,SECURITY FLAG SETTINGS ARE NOT BOUND,YOU CAN USE IT ON AS MANY PHONES AS YOU WISH WITHOUT HAVING TO CONNECT THE DEVICE TO PC EACH TIME. IN OTHER WORDS,IF YOU NEED TO LOCK/UNLOCK A PHONE,YOU MUST ADD PHONE'S IMEI TO SPECIAL 'CONFIG.DAT' FILE USING THE 'SD EDITOR' TAB. THE SIM LOCK SETTINGS ARE BOUND TO THE PHONE'S IMEI. Insert XTC 2 Clip device into phone SD card slot,power on phone into bootloader mode using 'vol-down + pwr' button and select 'SIMLOCK' option.

Select the options you need and press 'Save to drive' If you have previously had your service files on your device,please press 'Read from drive' button,otherwise you will lose all your existing files once used the 'Save to drive'. Run the XTC 2 Clip software and select 'SD editor' tab. The device will be detected as a flash/disk drive.

#Xtc clip box how to

How to prepare service files on XTC 2 Clip device:Ĭonnect the XTC 2 Clip device to your PC using any compatible microsd card reader. IF YOU GET A 'SD CARD NOT FOUND' MESSAGE–IT MEANS THAT THE XTC 2 CLIP WAS CONNECTED AFTER PHONE WAS POWERED ON.IN THIS CASE PRESS THE 'REBOOT BOOTLOADER' BUTTON AND REPEAT THE DESIRED OPERATION. SIM LOCK FUNCTION IS NOT AVAILABLE IN DIRECT MODE! PLEASE USE OFFLINE MODE FOR SIM LOCK MANAGEMENT. Run the XTC 2 Clip software and select 'Direct mode'.Ĭhoose the desired operation and press corresponding button. Insert XTC 2 Clip device into phone SD card slot,power on phone into bootloader mode using 'vol-down + pwr' button.And select 'FASTBOOT' option. Offline–when using a SIM Lock menu of bootloader.To use the offline mode you must first save special service files on XTC 2 Clip device. There are 2 operation mode for XTC 2 Clip device:ĭirect–when the phone is in fastboot mode & connected to the PC,using the XTC 2 Clip software In order to use its functions – you have to connect it to the SD card port of your phone.The SD port may be located on the left, right or rear (battery) part of your phone.If your phone has no SD port–you must use Y-cable.

XTC 2 Clip is supposed to support the whole range of HTC phones,however the features may differ from model to model.īelow is the list of tested models as per : XTC 2 CLIP + XTC 2 Clip Power Dongle +Y Cable Repair for HTC New Phones CID MEID